Noise And Vibration; Overview (Figure A); Instructions For Use - Flex GE MH 18.0-EC Manual De Instrucciones

Noise and vibration

NOTE
Values for the A-weighted sound pressure
level and for the total vibration values can be
found in the "Instructions for use" table.
The noise and vibration values have been
determined in accordance with EN 60745.
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured
in accordance with a standardised test
given in EN 60745 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emis-
sion level represents the main applications
of the tool. However if the tool is used
for different applications, with different
accessories or poorly maintained,
the vibration emission may differ.
This may significantly increase the expo-
sure level over the total working period.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly decrease
the exposure level over the total working
period. Identify additional safety measures
to protect the operator from the effects
of vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
20

Overview (Figure A)

1 Sanding head
with closed brush ring
2 Gimbal bearings
3 Dial for preselecting the speed
4 Locking button
5 Switch
6 Filter cover
7 Slot for battery
8 32 mm connection
9 Flex Li-ion battery
10 Release button for battery
11 State of charge indicator
12 Suction hose
13 Bail handle (optional)
14 Orbital sander head
15 Sanding head
with open brush ring for sanding edges
16 Delta sander head
17 Fastening screws
18 Orbital Velcro plate
19 Brush ring
20 Screw
21 Retaining washer
22 Velcro pad
23 Backing pad
24 Replaceable protective corners
25 Delta Velcro plate

Instructions for use

Before switching on the power tool
 Unpack power tool and accessories
and check that no parts are missing
or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.
Connecting the extractor (Figure B)
 Connect extraction hose to the 32 mm
connector.
GE MH 18.0-EC