Flex GE MH 18.0-EC Manual De Instrucciones página 21

GE MH 18.0-EC
NOTE
The connection piece of the GE MH 18.0-
EC is a new development.If electric power
tools are used with conventional connection
pieces together with the extraction hose
of the GE MH 18.0-EC, an adapter from the
FLEX accessories programme can be used.
Attaching/changing the sanding
head
CAUTION!
Remove the battery before carrying out any
work on the power tool.
To attach (Figure C):
 Press the two locks on the tool change
head (1.).
 Put the tool change head on the sanding
head (2.).
 Check that the locking mechanisms have
returned to the home position.
To change (Figure D):
 Press the two locks on the tool change
head (1.) and remove sanding head (2.).
NOTE
The delta sander head and orbital sander
head are attached/changed in the same
way.
Inserting/replacing the battery
(Figure E-F)
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Using a dust extraction system
CAUTION!
When using the wall sander, connect
–
a Class M dust extractor.
If a dust bag is used which is not autho-
–
rised for use with dry construction dust,
the amount of dust particles in the air
may increase at the work place.
Over a prolonged period high concentra-
tions of dust in the air may damage
the human respiratory system.
 Insert the special dust bag for dry con-
struction dust into your dust extractor
according to the instructions supplied
with the dust extractor.
 Connect extraction hose to the dust
extraction system. Follow the operating
instructions for the dust extraction sys-
tem! Check the attachment!
If required, use an appropriate adapter.
NOTE
If your dust extractor requires a special
connector, the clip-on connection can
be removed and a matching adapter selec-
ted from the FLEX accessories range.
Attaching and changing the sanding
tools (Figure H)
CAUTION!
Remove the battery before carrying out any
work on the power tool.
 Remove worn sanding tool from
the Velcro pad.
 Place the sanding sheet in the centre
of the Velcro pad and press on.
 Conduct a test run to check that the san-
ding tool is clamped in the centre.
CAUTION!
Never use the Velcro pad as a sanding tool.
Never use the wall sander without the san-
ding sheet, otherwise the work surface will
be seriously damaged!
21