Haier AC12CS1ERA Manual De Instrucciones página 14

Installation Procedure
PREPARING INDOOR UNIT INSTALLATION
Remove the intake grill
Open the intake grill and remove the three or four or six screws.
Note:
The main unit can be wired before the indoor unit is installed.
Select the most appropriate installation order.
A.FLOOR CONSOLE TYPE
1.Drilling for piping
Select piping and drain directions. The piping and drain can be made
in three directions as shown in the Fig.1.
The drain hose can be connected to either the left or right side. (Fig.2)
When the directions are selected, drill a 7 cm dia. hole on the wall so
that the hole is tilted downward toward the outdoor for smooth water
flow. When the pipe is led out from the rear, make a hole at the position
shown in Fig.3.
When installing set to wall, install the accessory wall
bracket at the position shown in Fig. 4, and mount the
set to it.
2. Installing drain hose
Select whether the drain hose will be
connected to the left or right side (Fig.2). Insert
the drain hose into the drain pan, then secure
the drain hose with a nylon fastener (Fig.5).
Wrap the insulation (drain hose) around the drain
hose connection. (Fig.6)
Fig. 1
Fig. 2
Drain hose (Left side)
Fig. 3
Fig. 4
99cm
50cm
6.5cm
3.5cm hole
12.5cm
Fig. 5
Drain pan
Drain hose
Fig. 6
Drain pan
Drain hose
12
Intake grill
rear
right
down
Drain hose (Right side)
Wall
7cm
Indoor unit outdoor unit
24.5cm
Wall bracket
Side of set
7cm hole
10cm
Nylon fastener
Insulation
(Drain hose)
6mm