Cautions - Haier AC12CS1ERA Manual De Instrucciones

Cautions

Disposal of the old air conditioner
Before disposing an old air conditioner that goes out of use,
please make sure it's inoperative and safe. Unplug the air
conditioner in order to avoid the risk of child entrapment.
It must be noticed that air conditioner system contains
refrigerants, which require specialized waste disposal. The
valuable materials contained in a air conditioner can be
recycled. Contact your local waste disposal center for proper
disposal of an old air conditioner and contact your local
authority or your dealer if you have any question. Please
ensure that the pipework of your air conditioner does not get
damaged prior to being picked up by the relevant waste
disposal center, and contribute to environmental awareness
by insisting on an appropriate, anti-pollution method of
disposal.
Disposal of the packaging of your new air conditioner
All the packaging materials employed in the package of your
new air conditioner may be disposed without any danger to
the environment.
The cardboard box may be broken or cut into smaller pieces
and given to a waste paper disposal service. The wrapping
bag made of polyethylene and the polyethylene foam pads
contain no fluorochloric hydrocarbon.
All these valuable materials may be taken to a waste collecting
center and used again after adequate recycling.
Consult your local authorities for the name and address of the
waste materials collecting centers and waste paper disposal
services nearest to your house.
Safety Instructions and Warnings
Before starting the air conditioner, read the information given
in the User's Guide carefully. The User's Guide contains very
important observations relating to the assembly, operation
and maintenance of the air conditioner.
The manufacturer does not accept responsibility for any
damages that may arise due to non-observation of the
following instruction.
Damaged air conditioners are not to be put into operation.
In case of doubt, consult your supplier.
Use of the air conditioner is to be carried out in strict
compliance with the relative instructions set forth in the
User's Guide.
Installation shall be done by professional people. Don't install
unit by yourself.
For the purpose of safety, the air conditioner must be properly
grounded in accordance with specifications.
Always remember to unplug the air conditioner before
opening inlet grill. Always grip plug firmly and pull straight
out from the outlet.
All electrical repairs must be carried out by qualified
electricians. Inadequate repairs may result in a major source
of danger for the user of the air conditoiner.
Do not damage any parts of the air conditioner that carry
refrigerant by piercing or perforating the air conditioner's
tubes with sharp or pointed items, crushing or twisting any
tubes, or scraping the coatings off the surfaces. If the
refrigerant spurts out and gets into eyes, it may result in
serious eye injuries.
Do not obstruct or cover the ventilation grille of the air
conditioner. Do not put fingers or any other things into the
inlet/outlet and swing louver.
Do not allow children to play with the air conditioner. In no
case should children be allowed to sit on the outdoor unit.
When the indoor unit is turned on, the PCB will test if swing
motor is O.K., and then fan motor will start up.So there is a
few seconds to wait.
In cooling mode,the flaps will swing automatically to a fixed
position for anti-condensating.
This appliance is not intended for use by persons (including
children) with reducedphysical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
Specifications
The refrigerating circuit is leak-proof.
For all the models in this manual, the all-pole discon-nexion
connection method should be applied in the power supply.
Such means for disconnection must be incorporation in the
fixed wiring.
Indoor temperature
Cooling
Outdoor temperature
Indoor temperature
Heating
Outdoor temperature
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agentor a similar qualified person.
If the fuse on PC board is broken please change it with the
type of T 3.15A /250VAC.
The wiring method should be in line with the local wiring
standard.
The waste battery shall be disposed properly.
The indoor unit installation height is at least 2.5m.
The air breaker and the power switch should installed the
conveniently reachable pleace for user.
3
max. DB/WB 32/23 C
min. DB/WB 18/14 C
max. DB/WB
46/24 C
min. DB/WB
18 C
max. DB/WB
27 C
min. DB/WB
15 C
max. DB/WB
24/18 C
min. DB/WB -15 C