Health And Safety; Pre-Start Checks - Altrad Belle BGN+ Manual Del Operador

For your own safety, as protection for others, and to avoid damage to the motor, read carefully the following usage
recommendations.
· For the safe and proper operation of the 'BGN+', make sure that operators have been instructed in the correct use of this machine.
· Before connecting the motor to the electrical system, make sure that the voltage and frequency match with the ones stated on
the machine serial plate, located in the top part of the plastic housing.
· ENSURE that all housing screws are tight before starting work.
· AVOID the À attening of the cable by heavy machinery with could cause breakage.
· DO NOT CONNECT the À exible shaft to the power unit when it is working.
· DO NOT OPERATE the motor when this is working and without transmission.
· DO NOT WORK with transmission or poker in bad conditions, the motor overheats.
· DO NOT WORK with the plastic housing broken.
· DO NOT PERMIT untrained personnel to operate the motor or connections.
· MAINTAIN free ventilation of air.
· KEEP the motor in a clean and dry area.
· MAKE SURE that the electrical cable is with the proper section and functioning properly.
· BEFORE DOING any type of repair, DISCONNECT the motor from the electrical system.
· WHEN CONNECTING to a generator, make sure that the output voltage and frequency is stable, right, and has the proper power,
· WHEN FINISHING the job or when taking a break, the operator should unplug, disconnect it from the electrical system, and have it
placed in such a way that it should not fall or tip.
· In addition, all local regulations should be respected.
Vibration
Some vibration from the poker is transmitted through the À exible hose to the operator's hands.
PPE (Personal Protective Equipment).
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe capped
footwear. Wear clothing suitable for the work you are doing. Always protect skin from contact with concrete. Suitable ear defenders
Should be used because the acoustic power level of this machine is 92 dB and the acoustic pressure level is 86 dB.
1. Before starting the job, check the correct working of all the handling and safety devices.
2. Regularly inspect the condition of the cables and the rubber housing. When a defect is detected, repair immediately.
3. If defects are found in the safety devices or other defects which could reduce the safe handling of the equipment, stop working and
notify to the proper responsible person.

Health and Safety

Pre-Start Checks

9
GB
GB