Installing/ Removing The Brake Covers/ Clamping Protection Covers - Invacare Aquatec Ocean VIP Ergo Manual Del Usuario

4.2.9 Installing/ Removing the Brake Covers/ Clamping
Protection Covers
Brake cover
A
B Brake lever cover
Clamping protection cover
C
Brake Cover
1639504-E
1. Attach the brake lever cover A by pinning up the slot
B to the small shaft C.
2. Position the lower part of the brake cover D at an angle
from below over the brake housing E.
3. Fold the upper part of the brake cover to the brake
housing so that the recesses F sit flush with the edges
G.
4. Install the second brake cover on the other side.
Clamping Protecting Cover
1. Install the clamping protecting cover A by snapping it
onto the frame tubes B. Make sure that all clips C
are fully engaged.
2. Install the second clamping protecting cover on the
other side.
Setup
19