Before Using The Appliance For The First Time; Care And Maintenance - Rowenta PU2530 Manual De Instrucciones

WHERE TO INSTALL THE APPLIANCE
Place the purifier on a flat, stable surface in the room requiring treatment.
To allow the air to circulate freely, avoid placing the appliance behind curtains, below a window, item of furniture
or shelf unit, or close to any other obstacle, and leave at least 50 cm of free space on each side of the appliance.
Recommended to be used in ambient conditions lower than 35°C 70%RH.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME

Before the first use, ensure the voltage, frequency and power of your appliance suit your electric supply.
Your appliance can operate using an unearthed plug. It is a class II (double electrical insulation
Before switching on your appliance, ensure that:
- the appliance is completely assembled as described in the safety instructions,
- the appliance is placed on a stable, horizontal surface,
- the appliance is positioned in accordance with the instructions given in this manual,
- the air inlets and the oultet grid are completely unobstructed,
- the filters and panel have been correctly installed (See section "Disassembling / Reassembling filters")
IMPORTANT: You are advised to switch off and unplug the appliance when not in use.
OPERATION
• Power Switch (1)
– Turn the purifier on or off.
• Speed selection (2)
– You can select 3 purification speeds as required.
– Low gear: in this mode, the purification wind speed is small, and the noise is low ,which is suitable
when sleep.
– Middle gear: in this mode, the purification wind speed is increased , which is suitable under the good
air condition.
– High gear: in this mode, the purification wind speed is the largest, which can quickly purify pollutants
in the air ,suitable for the environment with poor air quality, such as when some one smoking.
• Sleep mode (4)
– In this mode, press the sleep key to count into the sleep mode, the purification wind speed is in the sleep
gear. Press the sleep key again then exit the sleep mode and automatically restore to the working mode
before entering the sleep mode.
• Child lock (5)
– In working mode, press and hold the timer button (3) plus sleep mode button (4) at the same time for 3
seconds to enter the child lock mode. Press and hold the indicator light of child lock for 3 seconds then
exit the child lock.
– In child lock mode, other keys are invalid.
• Timer (3)
– When the purifier is working, press the key to select the required working time(1,2,4,8 hours), and the
purifier will stop working after reaching the set time automatically.
– When the purifier is in standby mode, press the key to select the required scheduled working time
(1,2,4,8 hours).The purifier will start working when reached the set time.

CARE AND MAINTENANCE

Before performing any maintenance work, switch off the air purifier using the on/off button (1).
Use a damp cloth to clean the surface of the product.
Important: Do not use any abrasive materials, as these may damage the surface of the product.
EN
).
5