Connecting Power; Battery Installation; Initial Calibration - OHAUS Scout SPX Serie Manual De Instrucciones

TM
SCOUT SERIES BALANCES - SPX

2.4 Connecting Power

AC Adapter Installation
AC power is used to power the scale when battery power is not needed. First, connect the AC
Adapter (supplied) to the AC Adapter Input Jack at the rear of the balance then connect the AC
plug to an electrical outlet.
AC Adapter Input Jack
Interface Connection

Battery Installation

Note:
After power on, it is recommended to warm up the balance for at least 5 minutes before using it.

2.5 Initial Calibration

When the Balance is first installed, and when it is moved to another location, it must be
calibrated to ensure accurate weighing results. Have the appropriate calibration masses
available before beginning calibration. Refer to the Calibration Section for masses and
calibration procedure.
Find Quality Products Online at:
Weigh Below Hole
Security Switch
Security slot (Anti-theft lock slot)
Battery Compartment Cover
Figure 2-4. Rear and bottom view of balance
GlobalTestSupply
www. .com
sales@GlobalTestSupply.com
EN-3