Location; Installation - Hoshizaki FM-1000AKE Manual De Instalación

5) Remove the protective plastic film from the panels. If the icemaker is exposed to the sun or to heat, remove the film after the
icemaker cools.

4. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 5°C to 40°C. Water connection is cold water only. Operation of the
icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Top View (except FM-600AKE)
Rear
15cm
Left
15cm
ICEMAKER
Front
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the manufacturer cannot be held
responsible.
1) Fully screw in the four legs provided (bin accessory) into the storage bin underside.
2) Position the storage bin in the selected permanent side.
[Except FM-170]
3) Remove the tape from the chute opening at the bottom of the icemaker.
[Except FM-170]
4) Pull down the end of the string coming out of the chute opening
to remove the cushion.
Note: If the power supply is turned on with the cushion left inside,
the icemaker will not start showing "BIN FULL" in the display.
5) Place the icemaker on top of the storage bin by holding the
bottom.
IMPORTANT
Top View (FM-600AKE only)
Right Left
15cm
30cm
WARNING
CAUTION
NOTICE
Rear
15cm
Right
30cm
ICEMAKER
Front
CAUTION
3
ENGLISH
Side View Top
60cm
Front
15cm
ICEMAKER
Bottom Plate
Adjustable Legs
Tape
Rear
String