Astralpool 37059 Manual De Instalación página 15

22
Drill the 4 holes with a Ø8mm bit.
The installation of the foam pads, like the fastening (screws, washers, joints, etc.),
must be done with care to ensure waterproofing and smooth functioning of
your device.
24
Replace the 4 pieces of stabilizing foam.
26
x 4 x4
Tighten the 4 screws with their washers
(provided with the fastening kit). Installing
the washers guarantees that your
device is waterproof.
27
Check the immersion depth.
23
Position and push in the 4 rawplugs. These
must be flush with the coping.
25
Reposition the device on the coping.
Joint properly
compressed.
28
x 4
x4
Always put the 4 small joints in
place (provided with the fastening kit).
Installing the joints guarantees that your
device is waterproof.
14
Joint not compressed
properly.