Listening To Fm And Am Broadcasts; Tuning In A Station; Presetting Stations; Tuning In A Preset Station - JVC PC-X270 Manual De Instrucciones

Listening to FM and AM Broadcasts

Tuning in a Station

1
Press TUNER.
The unit automatically tunes in the previously
tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Start searching for stations.
Press and hold 4 or ¢ for
more than 1 second.
The unit starts searching for stations and
stops when a station of sufficient signal strength is tuned
in. If a program is broadcast in stereo, the STEREO
indicator lights up.
To stop during searching, press 4 or ¢ .
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE so that the MONO
indicator lights up on the display. Reception
improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.

Presetting Stations

You can preset 20 FM and 12 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Tune in the station you want to preset.
• See "Tuning in a Station" above.
FM
MHz
2
Press PROGRAM/SET.
CH
3
Press PRESET/REPEAT
to select a preset number.
CH
4
Press PROGRAM/SET
again.
FM
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
FM MODE
The preset stations will be erased in a few days. If this happens,
preset the stations again. If the batteries are inserted in the unit, this
has no effect on the memory.

Tuning in a Preset Station

1
Press TUNER.
The unit automatically tunes in the previously
tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Select a preset number.
On the unit:
Press PRESET/REPEAT.
On the remote control:
Press the number buttons.
For preset number 5, press 5.
For preset number 10, press +10,
then 0.
For preset number 15, press +10,
then 5.
For preset number 20, press +10,
+10, then 0.
– 10 –
7
CH
MHz
7
3
6
9
1 2
4 5
7 8
0 +10