Important Safety Instructions; Electrical Characteristics; Recommended Mounting Heights - Bobrick InstaDry B-7125 Instrucciones De Instalación

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS
*
**
Electric Hand dryer intended for use in a household environment by
non-expert users. Not suitable for outdoor use.
*** This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without supervision.
**** If a fault develops disconnect the electrical supply, a qualified
electrician should be called.
SAVE THESE INSTRUCTIONS
*****
Universal Voltage: -110V–240V, 50/60 Hz, 200 Watts, cULus Listed and CE marked.
Distance from floor to bottom mounting screw holes of mounting base. (Dimension A)
Men's Washrooms ................................................................................................................................................46''
Women's Washrooms ...........................................................................................................................................44''
Children's Washrooms, ages 3-4 ..........................................................................................................................36''
Children's Washrooms, ages 5-8 ..........................................................................................................................40''
Children's Washrooms, ages 9-12 ........................................................................................................................44''
Universal Design ........................................................................................................................................... 40"-48'' (1015-1219mm)
*
Bobrick automatic hand dryers should be installed 15" (380mm) above any projection or horizontal surface which may interfere with
the operation of the automatic sensor.
1. Start installation of dryer by removing cover. To remove
cover,insert Allen wrench (provided with dryer) into cover
bolts which are equally spaced on bottom of cover and turn
COUNTERCLOCKWISE (see adjacent illustration.) Cover
bolts do not need to be completely removed and can remain in
position on baseplate ready to refit the cover.
2

Electrical Characteristics

Recommended Mounting Heights

Removal of Cover
x 2
Form No. 7125-69_ii (Rev. 12/22/17)
Hand Dryer
2. To remove cover, place a hand on each side of cover and
follow the sequence shown in the illustrations. Sequence is as
follows:
a. Disengage cover from cover bolts on baseplate.
b. Disengage cover from top of baseplate.
c. Remove cover from unit.
© 2017 Bobrick Washroom Equipment, Inc.
A
B
C
(1168mm)
(120mm)
(915mm)
(1015mm)
(1120mm)