GE TFM20JRB AA Manual Del Usuario página 16

About the ice and water dispenser.
16
Ice Storage Bin
To remove:
Lift the left corner to free the bin from
the shelf and pull the bin straight out
while supporting it at front and rear.
To replace:
Slide the bin back until the tab on the
bin locks into the slot on the shelf. If the
bin does not go all the way back, remove
it and rotate the drive mechanism 1/4
turn. Then push the bin back again until
the tab on the bin locks into the slot on
the shelf.
Important Facts About Your Dispenser
Add ice before filling the glass with a
beverage.
Do not add ice from trays or bags to
the storage bin. It may not crush or
dispense well.
Avoid overfilling glass with ice and use
of narrow or extra-tall glasses. Backed-
up ice can jam the chute or cause the
door in the chute to freeze shut. If ice
is blocking the chute, poke it through
with a wooden spoon.
Beverages and foods should not be
quick-chilled in the ice storage bin.
Cans, bottles or food packages in the
storage bin may cause the icemaker
or auger to jam.
(On some models)
Rotate
Drive
Mechanism
Some crushed ice may be dispensed
even though you selected CUBED ICE.
This happens occasionally when a few
cubes accidentally get directed to the
crusher.
After crushed ice is dispensed, some
water may drip from the chute.
Sometimes a mound of snow will form
on the door in the ice chute. This
condition is normal and usually occurs
when you have dispensed crushed ice
repeatedly. The snow will eventually
evaporate.
Dispensed water is not ice cold. For
colder water, add crushed ice or cubes
before dispensing water.