GE TFM20JRB AA Manual Del Usuario página 7

When Your Refrigerator Is First Plugged In
All panel lights come on for five seconds,
a beep sounds, and lights go off except
as follows:
PF flashes in the display. Touch
SYSTEM CHECK-RESET to erase it.
NORMAL glows.
WARM TEMP glows until the refrigerator
cools down. It goes off when proper
food-keeping temperature is reached.
How to Set the Door Alarm
DOOR ALARM
ON/OFF To set the alarm press DOOR ALARM
until it glows.
The control beeps if either door is
open for more than 30 seconds.
The light goes out and the beeping
stops when you close the door.
Why the WARM TEMP Light Glows
At first, it's probably because your newly-
WARM
installed refrigerator hasn't completely
TEMP
cooled down yet. Wait a few hours for it
to cool, and then the light will go out.
From then on, WARM TEMP will glow
whenever temperatures inside get too
high for proper food storage. If this
happens, open the doors only when
absolutely necessary, and close them
as quickly as possible.
How the Monitor and Diagnostic System Works
SYSTEM The diagnostic code flashes and the
CHECK
control beeps when something starts to
RESET
go wrong.
If more than one coded function requires
attention at the same time, the one with
the highest priority will be displayed first.
Door alarm beeper is activated and
DOOR ALARM glows.
CRUSHED ICE glows.
DOOR OPEN flashes if either door is
open, goes out when doors are shut.
Night light in ice and water dispenser
is off.
As soon as inside temperatures return to
normal, the light goes out.
If WARM TEMP reappears and stays on
for longer than 4 hours, call for service.
Pressing SYSTEM CHECK-RESET will erase
two codes immediately— PF and CI. The
dE and FF codes can only be erased by
pressing SYSTEM CHECK-RESET after the
condition that caused the code to flash
has been corrected.
SYSTEM CHECK-RESET will also evaluate
all other coded functions. If NORMAL is
lit during the displaying of a code, that
function is operating properly.
7