Door Alignment; Dimensions And Specifications - GE TFM20JRB AA Manual Del Usuario

Preparing to install the refrigerator.

Door Alignment

(available on some models)
After leveling, make sure that doors are even at the top.
To make the doors even, adjust the fresh food door. Using a 3/16" Allen wrench or a 5/16" socket wrench
(depending on model), turn the door adjusting screw to the right to raise the door, to the left to lower it. (A nylon
plug, imbedded in the threads of the pin, prevents the pin from turning unless a wrench is used.) After one or two
turns of the wrench, open and close the fresh food door and check the alignment at the top of the doors.
Remove base grille by opening
the doors and pulling the grille
straight out.

Dimensions and Specifications

22
(for Built-In models)
"
70 1 /
4
(178.4 cm)
36"
(91.4 cm)
24" (61 cm)
3/16" Allen Wrench
Raise
5/16" Socket Wrench
or
Raise
Water
3/4" (2 cm) Airspace
(1/2" [1.3 cm] Gap +
1/4" [0.6 cm] Wall Plates)
24" (61 cm)
24" (61 cm)
Cabinet
Side Panels
Electrical
25" (63.5 cm)
Counter Top