2-Cup Function; Preparing Hot Water - Krups ESPRESSERIA AUTOMATIC PREMIUM Manual De Instrucciones

IFU display-GB hors tuv.qxd:Mise en page 1
Press the button, wait for the end of pre-heating and perform a rinsing operation if you wish.
Each time you plug your machine in, it will carry out an initialisation cycle.
The drink selection
menu will be displayed.
To stop coffee flowing into the cup, you can either again press a key or turn the rotating button to reduce
volume.
The amount of water required for a coffee is between 80 and 160 ml.
The amount of water required for a long coffee is between 120 and 240 ml. The machine automatically carries out a double
cycle, do not remove your cup before the process has ended.
The ground coffee is first moistened using a little hot water after the grinding stage.
A few moments later, percolation as such begins.
There is a temperature setting function to control how hot your coffee is (see § Settings).
DO NOT REMOVE THE WATER COMPARTMENT BEFORE THE END OF THE CYCLE
(that is around 15 seconds after the coffee has finished dripping through).
Your appliance enables you to prepare 2 cups of coffee or espresso for the following 3 kinds of drink :
espresso / strong espresso / coffee. For "Large coffee" drinks, the 2-cup function is not available.
Remember not to remove the cups after the first cycle.
You have now prepared your appliance. The drink select menu will be displayed.
Put two cups under the cof-
fee outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum amount of hot water per cycle is limited to 300 ml.
27/01/09
Put a cup under the coffee
outlets.
You can lower or raise the
coffee outlets to suit the
size of your cups.
MAKING A COFFEE
MAKING A LONG COFFEE

2-CUP FUNCTION

x 2
Select your drink and confirm by
clicking twice on the OK key. A
message will appear to tell you
that you have chosen two cups.

PREPARING HOT WATER

While the screen displays the drink selection menu, press the "hot water" key
A message will invite you to place a container under the steam nozzle. Again press
the "hot water" key to produce hot water.
6
9:08 Page 6
Use the rotating button
to select your drink and
confirm by pressing the
OK key.
The appliance will
automatically sequence 2
complete coffee-making
You can change the
volume of water at any
time using the rotating
button.
cycles.
.