Silverline 264153 Instrucciones Originales página 9

Ocultar thumbs Ver también para 264153:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
264153
• When cutting, always keep the angle of the disc constant. Do not apply any
sideways force to cutting discs, as this might lead to the disc becoming
jammed in the cut and shattering
WARNING: Do not apply too much pressure to the machine whilst cutting.
Excessive pressure does not result in more effective or faster cutting, but will
in fact cause premature wear of the cutting disc and increase wear and tear
on the machine.
Note: The cutting disc will wear during use, and the disc diameter will
gradually reduce in size. The smaller the disc becomes, the more strain will be
placed on the motor. Avoid damage to the machine by only using cutting discs
that fall within approximately 25% of the original size.
Using a cup brush or wire wheel
• Always check the no-load speed of the grinder does not exceed the
maximum speed of the cup brush or wire wheel
• Ensure no part of the cup brush or wire wheel can come into contact with
the machine housing
• Run the grinder, with cup brush or wire wheel attached, for at least 30
seconds before use to check that the cup brush or wire wheel is secure and
properly balanced
• When using a wire cup brush or wire wheel, avoid applying excess
pressure. Using greater force will not make the cup brush or wire wheel
more effective, but will bend the wires out of shape and damage the brush
Accessories
• A range of accessories and consumables, including Cutting Guard (847124),
Metal Cutting Discs Flat (447131) and Stone Cutting Disks Flat (199875),
is available from your Silverline stockist. Spare parts can be obtained from
toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out
any inspection, maintenance or cleaning.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
This advice also applies to extension cords used with this tool
• if the replacement of the supply cord is necessary, this has to be done by
the manufacturer or his agent in order to avoid a safety hazard
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the machine's service life. Clean the body of
your machine with a soft brush, or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not
use alcohol, petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray
lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or
visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised Silverline service centre
• Note: One set of Spare Carbon Brushes is supplied with this tool.
115mm Angle Grinder
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are
no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
www.silverlinetools.com
9

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido