Door Adjust; Reversing The Door - Viking 5 Serie Manual De Instrucciones

Installation
Door Adjustments
DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or not sealing properly. If
the door is not sealed, the unit may not cool properly, or excessive
frost or condensation may form in the interior.
NOTICE
Properly aligned, the door's gasket should be fi rmly in contact
with the cabinet all the way around the door (no gaps). Carefully
examine the door's gasket to ensure that it is fi rmly in contact
with the cabinet. Also make sure the door gasket is not pinched
on the hinge side of the door.
!
CAUTION
Do not attempt to use the door to raise or pivot your unit. This
would put excessive stress on the hinge system.
Alignment and Adjustment Procedure
1. Open door and remove gasket near the hinges.
2. Using a T-25 Torx bit, loosen each pair of Torx head
screws both the upper and lower hinge plates.
3. Square and align door as necessary.
4. Tighten Torx head screws on hinge.
5. Reinstall gasket into the channel starting at the corner.
T-25 Torx Screw
T-25 Torx Screw

REVERSING THE DOOR

1. Open door.
2. Using T-25 Torx bit loosen screw #1 and remove screw #2 on
top and bottom hinge. Slide and remove the door from the
unit.
2
Note: One hinge includes a metal spacer. Spacer must be used
with that hinge when reversing the door.
3. Remove caps from screw heads on opposite side (2 on top and
2 on bottom). Using #2 Phillips bit, remove the 4 underlying
screws. Reinstall the screws and caps on the opposite side.
4. Partially install screw #1 in the outer most holes on top and
bottom. Rotate door 180o, align hinge over screw #1 and
slide/seat into position. Reinstall screw #2 on top and bottom.
Tighten both screws and install hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT).
9
1