Terminal Emulation Applications; Dr Series - Expansion Shelf Cabling - Dell DR Serie Manual De Instrucciones

• Hardware
– BIOS
– RAID controllers
– Hard drives (internal)
– Hard drives (external)
– USB flash drives
– Network interface controllers
– iDRAC Enterprise
– Marvell WAM controller
• Software
– Operating System
– Supported backup software
– Network file protocols and backup client operating systems
– Supported web browsers
– Supported system limits
– Supported OST software and components
– Supported RDS software and components

Terminal Emulation Applications

To access the DR Series system command line interface (CLI), the following terminal emulation applications can be
used:
• FoxTerm
• Win32 console
• PuTTY
• Tera Term Pro
NOTA: The listed terminal emulation applications are not the only ones that works with the DR Series system. This
list is only intended to provide examples of terminal emulation applications that can be used.
DR Series — Expansion Shelf Cabling
Each DR Series system appliance is capable of supporting additional storage capacity and install and connect up to two
Dell PowerVault MD1200 data storage expansion shelf enclosures. Each of the expansion shelf enclosures contains 12
physical disks that provide additional data storage capacity for a basic DR Series system. The supported data storage
expansion shelves can be added in 1 Terabyte (TB), 2TB, or 3TB hard drive capacities.
recommended method for cabling between the DR4000/DR4100 PERC controller card to the appropriate connectors on
the rear of the Dell PowerVault MD1200 expansion shelf enclosure.
NOTA: The 300 Gigabyte (GB) drive capacity (2.7 TB) version of the DR Series system does not support the addition
of expansion shelf enclosures.
Make sure that the Dell PowerVault MD1200 front panel selector switch is set to its Unified mode (with the switch set to
its "up" position, indicated by a single Volume icon).
Module (EMM) on the rear of the Dell MD1200.
which includes cable connections from both PERC H800 connectors on the DR4000 system (or the PERC H810 on a
DR4100 system) to the two SAS In ports on the EMM rear chassis of the Dell PowerVault MD1200.
If you plan on installing the second of the two supported expansion shelf enclosures in Release 2.0, then the two SAS In
ports on the rear chassis of the EMM on the second enclosure are daisy-chained to the two SAS Out ports on the EMM
32
figure 1 shows the SAS In ports on the Enclosure Management
Figure 2 shows the recommended redundant path cabling configuration,
figure 1and Figure 2display the