Chapter 5. Film Features; Films To Be Used; Band A Calculation; Chapter 6. Safety Standards - Minipack-Torre Modular 50 Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter 5. Film features

5.1. Films to be used

The machine can work with all thermoshrinkable and non-thermoshrinkable films, from 15 to 50 microns in thickness, of a
technical and food type. To guarantee the best results, it is recommended to use the films marketed by us.
The special features of our films (which may be customised with drawings and text) assure their outstanding reliability,
with regard both to compliance with laws in force and to an excellent machine performance.
It is recommended to refer to the technical and safety sheets of the films in use and to observe the
corresponding instructions!
Modular 50 A = mm600 MAX
Modular 70 A = mm800 MAX
5.2. Calculation of band A
Band A = b + c + 100 mm (figure 5.2. page 61).

Chapter 6. Safety standards

6.1. Warnings

THE MACHINE CAN NOT BE USED BY UNTRAINED PERSONNEL!
During the work phases pay attention to all hot parts of the machine. The temperature they can
reach is so high that it can cause burns.
It is forbidden to smoke when the machine is working!
Before starting the automatic cycle, make sure that all necessary adjustments have been made.

All adjustments of the machine will be made by the selector (6) in "MAN." position (figure 6.1.A page 61).

In case of blocking of the machine or in order to stop it during the automatic cycle press the EMERGENCY
PUSHBUTTON (8) (figure 6.1.A page 61).
Do not touch the sealing blade (27) soon after sealing by reaching beyond the safety guard (28). Danger of burns

due to residual heat on the sealing blade(27) (figure 6.1.B page 61).
Do not keep on sealing in case the sealing blade breaks (27) but replace it at once (figure 6.1.B page 61).

Do not touch the conveyor belt (19) when it is in motion (figure 6.1.B page 61).

Make sure that the roll of film is properly lodget (31) (figure 6.1.C page 61).


Chapter 7. Ordinary maintenance

7.1. Precautions for ordinary maintenance interventions

ORDINARY MAINTENANCE, MUST BE EXECUTED BY QUALIFIED STAFF APPROPRIATELY TRAINED.
Before proceeding to maintenance, switch the machine off and disconnect it by operating on the
master switch and wait for the machine to cool down!
It is recommended to use protection gloves during maintenance operations!

7.2. Sealing blade cleaning

Using a dry cloth, wipe off the residues clinging to the sealing blade: do this at once after sealing since the residues

are easier to remove when still warm.
Periodically lubrificate the sealing blade with the grease supplied with the machine (figure 7.2 page 62).

D = mm300 MAX
D = mm300 MAX
14
d = mm77 (figure 5.1. page 61).
d = mm77 (figure 5.1. page 61).
EN
EN
EN