Installation And Use - MELICONI HP400 Instrucciones De Uso

The box contains all the articles listed below:
1. IR Receiver wirh earpieces
2. Transmitter base
3. 1 m audio cable
4. Power supply unit
5. Manual
6. 2 rechargeable AAA batteries
TRANSMITTER BASE: (fi gure A)
1. Stereo/mono/microphone selector switch
2. Jack connector for all audio inputs
3. Power supply input jack connector
4. IR transmitter window
RECEIVER: (fi gure B)
1. On/off button.
2. On/off indicator LED.
3. Battery compartment (rear).
4. Tone control for improved speech quality and clarity (low-medium-high).
5. Left and right earpiece
6. Battery charger contacts
7. Battery charging indicator LED
8. Volume control
CONNECTING THE TRANSMITTER TO THE TV OR OTHER AUDIO SOURCES
- Disconnect the devices from the electrical mains supply before connecting them.
- Set the transmitter base selector switch to stereo mode.
- Using the audio cable (supplied), connect the transmitter base to the audio output jack connector on your TV
(or audio source) as illustrated.
- Connect and insert the power supply as illustrated. Reconnect the TV (or audio source) to the mains supply.
The red IR diodes are lit faintly behind the IR transmitter window while the TV and/or audio source is switched
on in order to indicate that the signal is being transmitted.
- Set TV volume to a suitable level. On most television sets it is possible to silence the loudspeakers while still
being able to listen to the signal on HP400
14
Box contents

Installation and use

DETAILED DESCRIPTION OF ARTICLES
(microphone NOT supplied)
(Figure C)