Stopping The Tying Tool; Storing The Tying Tool; Troubleshooting; Error Code Numbers List - CAMPAGNOLA NEXI Manual De Uso

Ocultar thumbs Ver también para NEXI:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33
WARNING!
If the front tying opening (10) of the tool gets blocked due to foreign material while tying, remove this stuff after
switching off.
Stopping the tool
The tool must be switched off at the end of each work session, therefore:
Put the ON/OFF button (7) in "off" position
Remove the battery (14)
Carefully put the tool and the batteries into the carrying case.
Storing the tool
Switch the tool off and remove the battery.
Recharge the battery (14) before putting it into its case.
Clean and lubricate the tool before storing it with its components in the carrying case.
Store the tool in a dry place.
During long periods of inactivity recharge the batteries not later than every 3 months.

Troubleshooting

WARNING!
All the following maintenance operations shall be carried out by a maintenance technician.
FAULT
The tool does not
work
Failed or wrong tying
operation
The hook has not re-
tracted
The battery cannot
get charged up

Error code numbers list

Kind of alarm
Current sensor error
Damage to the mosfets
Hall sensor
Peak overcurrent / medium current protection
Blocked front tying opening / blocked motor
Lack of phase
Undervoltage / overvoltage
Mosfet overheating
EEPROM error
Phase detection error
Schedule error
Interval is over: it is maintenance time
WARNING!
Neglecting to follow the instructions in the manual could cause damages or injuries.
Use and maintenance manual – Translation of
original Instruction.: 00, Date 23/09/2020
POSSIBLE CAUSE
Flat battery
Disconnected battery
Possible electronic or me-
chanic problem
Foreign material
Failed tie supply
Too quick tool detachment
from the branch
Failed tying operation
Damaged battery
Faulty battery charger
Unfit battery charger
REMEDY
Recharge the battery (14)
Check the proper connection of the battery (14) with the tool
Take the tool to an Authorized Service Point
Check and remove foreign materials and residual tie pieces
Remove the blocked tie from the supply line and then re-insert it.
Wait till the end of the tying operation before detaching the tool
from the branch.
Switch the tying tool off, retract the hook (4) manually and re-
move the residual tie on the tying wheel.
Replace the battery (14).
Replace the battery charger (17).
Check whether the battery charger is the one supplied with the
tool.
Quantity of flash-
ings on the display
2
3
4
5
6
7
8
9
11
12
13
15
Quantity of beeps
Kind of error shown
on the display
6
6
3
5
3
4
1
6
6
4
6
8
E02
E03
E04
E05
E06
E07
E08
E09
E11
E12
E13
E15
Page 29

Publicidad

Tabla de contenido
loading

Tabla de contenido