Craftsman 152.229000 Manual Del Usuario página 15

Figure 5-3 Figure 5-5
\
zj _
G F
H
N
NOTE: Make certain that the chuck arbor (F) and the
tapered hoUein the chuck (G) are dean and free of
grease, Uacquer,or rust preventive coatings, See
Figure 5-3, HousehoUd oven cleaner can effectiveUy
remove any substance from the spindUe and chuck,
Carefully follow the manufacturer's safety ruUescon-
cerning its use,
4, Open the chuck jaws completeUy, hoUdthe top collar
(H) and turn the chuck barreU (U)counter-clockwise,
Make sure the jaws are compUeteUyrecessed inside
the chuck, See figure 5-3,
Figure 5-4
7, Hace cord sUeeve (M) onto Hght cord (N), See
Figure 5-5,
Figure 5-6
0
5, Seat the chuck onto the chuck arbor as far as it wHU
go,
6, Carefully drive the chuck and chuck arbor into the
ddH press spindUe (J), Hace a wooden Mock (K)
under the chuck and tap the Mock up with a
hammer (L), See Figure 5-4,
CAUTION: DO NOT tap directly on the chuck with a
metal hammer,
8, Place cord clamp (0) over cord sleeve and attach
the light assembly to the drill press with two M6 x
16mm hex socket head screws and lock washers
(P), See Figure 5-6,
NOTE: The light assembly can be mounted on either
side of the drill press,
15