CONCOA ADI 2062M Instrucciones Para La Instalación Y Operación página 5

as #2).
4. CONCOA publication ADE 872, Safety Precautions in Welding and
Cutting.
5. Local Ordinances
6. O.S.H.A. Standard 29 CFR
7. C.G.A. Pamphlet C-4, American National Standard Method of Marking
Portable Compressed Gas Containers to Identify the Material Contained.
8. C.G.A. Pamphlet G-4, Oxygen – Information on the properties,
manufacture, transportation, storage, handling, and use of oxygen.
9. C.G.A. Pamphlet G-4.1, Equipment Cleaned for oxygen service.
10. C.G.A. Pamphlet G-4.4, Industrial Practices for Gaseous Oxygen
Transmission and Distribution Piping Systems.
11. C.G.A. Pamphlet G-5, Hydrogen – Information on the properties,
manufacture, transportation, storage, handling, and use of hydrogen.
12. C.G.A. Pamphlet G-6, Carbon Dioxide – Information on the properties,
manufacture, transportation, storage, handling, and use of carbon
dioxide.
13. C.G.A. Pamphlet G-6.1, Standard for Low Pressure Carbon Dioxide
Systems at Consumer Sites.
14. C.G.A. Pamphlet P-1, Safe Handling of Compressed Gases in
Containers.
15. C.G.A. Safety Bulletin SB-2, Oxygen Deficient Atmospheres.
*C.G.A. pamphlets can be obtained from The Compressed Gas Association,
1235 Jefferson Davis Highway, Arlington, VA 22202-3239, (703) 979-0900.
Publications: (703) 979-4341. Fax: (703) 979-0134.
INSTALLATION
Please observe the previously mentioned safety precautions before actual
installation.
1.1 Before removing the cylinder cap, move the cylinder of gas to the work site:
a. Secure cylinder to floor, wall or bench with appropriate chain or stand
to prevent toppling.
b. Remove the cylinder cap.
c. Be sure the cylinder valve is tightly closed (clockwise).
d. Remove the cylinder valve plug, if any.
e. Inspect the cylinder valve and threads for damage or contamination.
1.2 Following procedures below, secure the regulator inlet connector to the
outlet connector on the cylinder. Use an open-end wrench, not a pipe wrench.
a. The connection should be easily threaded. Do not force. If it is not easy,
you may have the wrong regulator for the gas you are using.
b. LEFT HAND THREADS are used on some inlet connectors and are
indicated by a notch in the middle of the hex nut.
5