Hergom ARANDA Instrucciones Para La Instalación, Uso Y Mantenimiento página 60

5.- Periodically inspect the chimney and clean whenever necessary.
6.- Do not place the oven near combustible walls.
C.- DISTANCES FROM COMBUSTIBLE SURFACES
When installing the oven, observe the necessary safety distances for
the oven and chimney from combustible surfaces (wooden or papered
walls, wooden floors...).
Requirements and test methods", the following data on temperature
transferred to surfaces have been obtained:
Front floor of trihedral (100 cm)
Rear surface of device (70 cm)
Floor under the device
Side surface of device (60 cm)
D.- CONNECTING THE OVEN LIGHT
The oven light in your OVEN is ready to be connected directly to the power
supply. Observe the following indications only in the case of insert oven
models:
In Fig. 12 are the wiring diagram and the material (within the dotted line)
supplied by Hergóm.
The electrical unit supplied by Hergóm is made up of the following parts:
- Light protected by a shade with a heat resistance of 550 ºC
- Silicon, heat-resistant cable with three terminals to connect to the
light and surrounding polyurethane cover.
- 40W incandescent bulb with heat resistance of 300ºC
The remaining parts comprising the electrical installation must be
purchased by you (Switch, cables, connections, etc...)
If appropriate protection is used
on the said surfaces, the said
safety distances can be reduced.
Safety distances
respected when the lining on walls
or nearby areas may be damaged
or deformed
(varnish, paint, PVC ...)
During tests
accordance
UNE-EN 12815:2002 "Residential
cookers fired by solid fuel -
39 ºC
52 ºC
82 ºC
69 ºC
60
must
by temperature
performed
with the standard
be
in