Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL FLUE MOUNTING
BRACKET
DUCTED AND NON-DUCTED HOODS
1. Assemble the flue mounting brack-
et, adjusting outside width as shown.
Fig. 8.
2. Carefully center the mounting bracket
directly over the range hood location.
3. Secure the bracket assembly to the
ceiling using (2) 4.8 x 38 mm mount-
ing screws and dr ywall anchors.
Fig. 9. Make sure the bracket is pushed
into the corner, tight against the wall and
centered over the hood.

INSTALL THE HOOD

Note: Remove the plastic protective film
from all exterior surfaces, decorative
flues and filters, prior to final installation.
Remove filters. (Refer to the "Install Filters"
Section.)
DUCTED and NON-DUCTED INSTALLATION
1. Remove the electrical system box from
chimney frame by removing (2) 3.9 x 9.5 mm
screws. Fig. 10.
2. Attach electrical system box to frame using (2)
3.9 x 9.5 mm screws removed in Step 1 and
(2) 3.9 x 9.5 mm screws and (2) lock washers
from hardware bag.
3. Install hood onto the wall mounting brackets.
Fig. 11. Adjust leveling screws on mounting
brackets to level hood with floor.
3. Mark and install (2) additional screws as
shown. Use drywall anchors only if necessary.
ELECTRICAL
SYSTEM BOX
REMOVE (2)
3.9 x 9.5 mm
SCREWS
FIG. 10
FLUE MOUNTING BRACKET
DRYWALL ANCHORS
4.8x38mm
MOUNTING SCREWS
- 12 -
3.9 x 6 mm FLAT HEAD
BRACKET SCREWS
11¾"
INSTALL (4)
3.9 x 9.5 mm
SCREWS &
LOCK WASHERS
ON (2) SCREWS
4.8 x 38 mm
SCREWS
FIG. 8
FIG. 9
FIG. 11

Publicidad

Tabla de contenido
loading

Tabla de contenido