Publicidad
Idiomas disponibles
Idiomas disponibles
Howto use the TouchSensor
After the menu is displayed on the LCD monitor:
O
@ Slide your finger up and down on the sensor.
O Select [SET]. (Touch OK.)
[]
D
[]
To select an on-screen
button appearing
on
the left side, touch the portion of the sensor
next to the on-screen
button.
[]
To select an on-screen
button appearing
at
the bottom of the screen, touch the buttons
underneath
them.
r
Read these INSTRUCTIONS
to enjoy your CAMCORDER.
For more details on the
operations,
refer to the
GUIDEBOOK
in the supplied CD-ROM.
In order to view the GUIDEBOOK,
Adobe ®
Acrobat e Reader
TM
or Adobe ®Reader _
must be installed.
Adobe ® Readei "¢ can be loaded from Adobe's
web site: http://www.adobe.com/
|
Select your desired language with a single click.
The model name is indicated on the bottom of
your camcorder.
Read This First!
Make a backup
of important
recorded
data
It is recommended
to copy your important
recorded data to a DVD or other recording
media for storage. JVC will not be
responsible
for any lost data.
Make a trial
recording
Before the actual recording of important
data,
make a trial recording and play back the
recorded data to check that the video and
sound have been recorded correctly.
Reset the camcorder
it' it does not operate
correctly
This camera uses a microcomputer.
Factors
such as background
noise and interference
can prevent it from operating correctly. Close
the LCD monitor and remove the power
supply (battery pack or AC adapter) from the
camcorder,
then reattach it.
Precautions
on handling batteries
• Be sure to use the JVC BN-VF808U/
VF815UNF823U
battery packs.
• If the camcorder
is subjected to
electrostatic
discharge,
turn off the power
before using it again.
if a malfunction
occurs, stop using the
camcorder
immediately and contact
www,jvc,com
or by phone at 1-800-252-5722
Recorded data may be erased while the
camcorder
is being repaired or inspected.
Back up all data before requesting repairs or
inspections.
Because the camcorder
may be used
for demonstration
in a shop, the
demonstration
mode is set to on by defaumt
To deactivate the demonstration
mode, set
[DEMO MODE] to [OFF].
When
Using
an SD Card
• Operations
are confirmed
on the following
SD cards.
Class 4 or higher compatible SD or SDHC
card Panasonic, TOSHIBA,
SanDisk, ATP
SD card (256 MB to 2 GB) or SDHC card
(4 GB to 32 GB).
• If other media are used, they may fail to
record data correctly, or they may lose data
that had already been recorded.
_® MultiMediaCards
are not supported.
J
Publicidad
