Avigilon HD-H264-B1 Guia Del Usuario página 15

1. To set the motion detection area, perform one of the
following:
• Click Set All to set the motion detection area to span
the whole video image.
• Click Clear All to remove all motion detection areas on
the video image.
• Click anywhere on the video image to add or remove a
specific motion detection area.
2. In the Sensitivity field, enter a percentage number to
define how much each pixel must change before it is
considered in motion.
The higher the sensitivity, the smaller the amount of pixel
change is required before motion is detected.
3. In the Threshold field, enter a percentage number to define
how many pixels must change before the image is
considered to have motion.
The higher the threshold, the higher the number of pixels
must change before the image is considered to have
motion.
4. Click Apply to save your changes.
11