MO-EL 766N Uso Y Mantenimiento página 14

The upright bracket is studied for holding one appliance or two of
them in opposite position.
Before fixing the appliance on the upright, please ensure that
it is stable and solid. Preferably, use the upright that can be
ordered as accessory (cod. 2473). The feet must be opened
as far as the white evidenced line on the inferior tube reaches the
junction of the feet. Fix the feet to the ground in a proper way, and
then fix the upright to the ground using the chain (fig.5).
Ensure that the supply cable is well mounted and that it does not
come into contact with the reflector of the heater or that it does not
trail into the heated area. The supply cable can be fixed to the metal
pipe behind the reflector with plastic wrappers.
4. USE
The Fiore range consists of a 1200 W heater and an 1800 W heater.
The essential element of the heater is the halogen filled quartz linear
lamp with a tungsten element. The heater operates at full output al-
most immediately. The heating reaches a distance of about 3 meters
in front of the appliance.
Avoid exposing skin to the rays of the appliance for distances
less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances
less than 2.70 m.
All users should be made aware of all aspects of operation and safety
and these instructions should be retained for reference.
Switch on heater (in the models that have the switch) and confirm
that emitter is operating. Ensure that the heater is aiming its warmth
into the target area by adjusting heater angles as necessary by us-
ing the adjustment device on the bracket, after you have loosed the
screws of the half rings (fig.6).
Do not use the heater directly near a bathtub, a shower, a swimming
pool. In unoccupied premises it is recommended that the heating
system is switched off and isolated from the electrical supply.
5. MAINTENANCE
Mo-El Fiore heaters contain no moving parts and therefore very little
14