Starting And Using - Dalla Corte MINA Manual De Usuario

Starting
and using the machine
Follow the following instructions with the help of the scheme in Pic.1.
• Turn on the water tap ( Pic.1).
1
• Turn on the ON/OFF electric supply switch (
make sure the power light ( Pic.3) comes on.
• As soon as the machine has been turned on, the automatic auto-fill function starts filling the boiler
until the right level is reached; during this stage, the
• Once the filling phase is over, the brewing group will start heating up and the
• At the end of the heating stage, the
• Immediately afterwards, the boiler starts to heat up and the
temperature has been reached, the light will stop blinking.
• The brewing group can be used while boiler is still heating up.
Multi-function dial knob
By rotating the multi-function dial knob (M Pic.3) you can choose the desired functions, and therefore
every position of the dial knob will switch on one of the six lights (
Functions in this manual will be referred to as
Pic.1) and turn the machine switch clockwise (
7
light (Pic.3) comes on.
light will stop blinking.
light starts blinking. Once the pre-set
to
- .
Pic.2);
1
light will start blinking.
- if active).
NOTE
This heating sequence takes
place only when the machine
is switched on after it has been
switched off completely with
the main switch ( Pic.2).
1
This sequence allows
the machine to heat up without
using too much energy, thus
avoiding possible overload
troubles in the local power
system.
| 31