Safety Rules; General - Promax SATHUNTER Manual De Instrucciones

SATHUNTER USER'S MANUAL.

2. SAFETY RULES

2.1 General

∗
The safety could not be assured if the instructions for use are not closely
followed.
∗
Use this equipment connected only to systems with their negative of
measurement connected to ground potential.
∗
The mains adaptor is a Class I equipment. For safety reasons it must be plugged
to supply power lines with their ground.
∗
This equipment can be used in Overvoltage Category I installations and Pollution
Degree 2 environments.
∗
The mains adaptor must be used only indoors. It can be used in Overvoltage
Category II facilities and Pollution Degree 1 environments.
∗
When using some of the following accessories use only the specified ones to
ensure safety.
Mains power adapter.
Car lighter adapter.
Mains cord.
∗
Observe all specified ratings both of supply and measurement.
∗
Remember that voltages higher than 70 V DC or 33 V AC rms are dangerous.
∗
Use this instrument under the specified environmental conditions.
∗
The user is not allowed to perform changes inside the equipment. Any change on
the equipment must be done exclusively by specialized staff.
∗
When the equipment is powered by the AC adaptor, the negative of the
measurement will be at the ground voltage.
∗
Do not obstruct the ventilation system of the equipment.
∗
Use appropriate low-level radiation cables for input / output signals, especially on
high level signals.
∗
Follow the cleaning instructions described in the Maintenance paragraph.
11/2009 Page 5