Esp-101 Modifications - ESAB Remote junction Box Manual De Instrucciones

SECTION 3
Description of esp-101 modification: The wiring modification redirects the control signal from the ESP-101 internal so-
lenoid, to the pins within the torch connection panel receptacle. The control signal is then diverted to the solenoid within
the Remote Junction Box.
The hose modification (solenoid air bypass) directs the system air supply to the solenoid within the Remote Junction Box.
This ensures air at a sufficient pressure is immediately available to the PT-37 torch.
3.1 ESP-101 Modifications
Remove the top and right side panel of the power supply.
1. Redirection of solenoid control wiring:
a. Locate, disconnect and move the solenoid interconnect plug as
shown.
2. Air flow by-pass of internal solenoid:
a. Locate and remove the included supplied air coupling.
b. Disconnect both air hoses from the input and output of the solenoid, by pushing ring inward and
pulling hose.
(a) Supplied Air Coupling
Reverse Trigger and Solenoid
Interconnect plugs
From
SOLENOID
CONTROL
Figure 3-8. Interconnect Move
(b) Pushing ring inward -
pull hose out of
connector
20
INSTALLATION
To SOLENOID
SOLENOID INTERCONNECT (LOWER)
From
PANEL
RECEPTACLE