General; Inspection And Cleaning - ESAB Remote junction Box Manual De Instrucciones

SECTION 4
WARNING

4.0 General

If this equipment does not operate properly, stop work immediately and investigate the cause of the malfunc-
tion. Maintenance work must be performed by an experienced person, and electrical work by a trained elec-
trician. Do not permit untrained persons to inspect, clean, or repair this equipment. Use only recommended
replacement parts.
4.1 Inspection and Cleaning
Frequent inspection and cleaning of the ESP-101 is recommended for safety and proper operation. Some suggestions for
inspecting and cleaning are as follows:
A. Check work cable for secured connection to workpiece.
B. Check safety earth ground at workpiece and at power source chassis.
C. Check heat shield on torch. It should be replaced if damaged.
D. Check the torch electrode and cutting nozzle for wear on a daily basis. Remove spatter or replace if necessary.
E. Make sure cable and hoses are not damaged or kinked.
F. Make sure all plugs, fittings, and ground connections are tight.
G. With all input power disconnected, and wearing proper eye and face protection, blow out the inside of the unit using
low-pressure dry compressed air.
WARNING
H. Occasionally, bleed all water from the filter beneath the air filter.
Be sure that the wall disconnect switch or wall circuit breaker
is open before attempting any inspection or work inside of the
UNIT.
Water or oil occasionally accumulates in compressed air lines.
Be sure to direct the first blast of air away from the equipment to
avoid damage to the UNIT.
25
MAINTENANCE