Wrapping The Cuff Around Your Wrist - Nissei WS-1300 Manual Del Operador

BUTTON to confirm.
6. Day flashes. Adjust with M1 and M2 buttons and press POWER
BUTTON to confirm.
7. Hour flashes. Adjust with M1 and M2 buttons and press POWER
BUTTON to confirm.
The clock operates in 24-hour mode.
8. Minute flashes. Adjust with M1 and M2 buttons and press
POWER BUTTON to confirm.
The clock is set and the unit is turned off.
BATTERY REPLACEMENT INDICATION
Replace all the batteries when the battery replacement indication

WRAPPING THE CUFF AROUND YOUR WRIST

1. With the palm of your left hand up, put the cuff on your wrist so
that the display screen is on the same side as your palm. If it is
impossible to put the cuff on your left wrist, use your right wrist
for measurement.
2. Adjust the cuff, with your palm up, until its top edge is positioned
5 to 10 mm from the bottom of your palm. Place the unit at the
INSTALLING BATTERIES AND SETTING THE CLOCK
appears on the display or nothing is displayed when POWER
BUTTON is depressed.
About 300 measurements can be made after installation of new
AAA alkaline dry cells. The enclosed batteries are for monitoring,
and their life may be shorter than that of commercial batteries.
The used electrical and electronic products are not
household waste. Follow your national/local recycling rules
to dispose of them properly. In the EU countries, please
refer to waste management symbol(s) marked on the
package or the instrument.
Do not use rechargeable batterires.
center of your wrist.
3. Fasten the cuff around your wrist so that there is no space
between the cuff and your wrist. The cuff should fit snugly. Press
the surface of the cuff to make sure the hook and loop attaches
securely. Position the cuff directly against the skin. Take care
that your clothing is not caught beneath the cuff.
-13-
Fig.3 page 5