Correct Measuring Posture; Measuring Method - Nissei WS-1300 Manual Del Operador

CORRECT MEASURING POSTURE

1. Sit on a chair.
2. Lightly open your left hand, with your palm up, and put your
elbow on a table or stand.
3. Adjust the cuff to the same height as your heart with a
comfortable support such as a folded towel etc.
WHEN THERE IS NO TABLE AVAILABLE
Sit on chair. Adjust the cuff to the same height as your heart by
lightly applying your left arm to your breast. Lightly support your
arm by your right hand during measurement, but do not touch the
cuff.

MEASURING METHOD

Breathe deeply and relax!
Make sure the cuff is wrapped correctly and it is at the
same height as your heart.
Do not move, chat or strain your arm or hand during
measurement.
1. Press POWER BUTTON.
The cuff is automatically inflated to the applied pressure.
TAKING A MEASUREMENT IN BED
Lie on your back. Adjust the cuff to the same height as your heart
with a comfortable support such as a folded towel etc.
Measured data may vary slightly depending on the
posture during measurement.
Measurements should always be taken using the same
wrist in the same position.
If the cuff is lower (higher) than the heart, the measured
reading tends to become larger (smaller).
TO STOP MEASUREMENT
Press POWER BUTTON and the unit stops inflation,
discharges air rapidly, and then turns off.
Pressure (displayed value) starts to decrease and pulse is
indicated by heart mark.
When the measurement is complete, air is automatically released
from the cuff.
-14-
Fig.4 page 5
Fig.5 page 6