Symbols; Controls - Medline EntraFlo Instrucciones De Operación

7. Release the buttons
a. Below is the information that will be
shown:
RATE Display VOLUME DELIVERED Display
4r 405
8. If pump RATE and VOLUME DELIVERED
displays match the information shown in
step 7.a., the pump has the Free Flow Alarm
feature installed
9. Press and hold the OFF key to exit the Free
Flow Alarm test mode

Symbols

Serial Numbers less than 700000
Degree of Protection
IPX1
Provided by Enclosure
Medical Electrical Equip-
ment
1. Classified with respect
to electrical shock, fire and
mechanical hazards in ac-
cordance with UL60601-1
2. Classified with respect to
electrical shock, fire, me-
chanical and other specified
hazards in accordance with
CAN/CSA C22.2 No.601.1
Serial Numbers 850000 or greater
Class II Equipment
Degree of Protection
IP21
Provided by Enclosure
Follow Instructions
For Use
Alternating Current
ON (Power)
OFF (Power)
Intertek ETL Classified for
Medical Electrical Equip-
ment to IEC 60601-1:2005,
IEC 60601-1-11: 2010, CSA
C22.2#60601-1:2008
All Serial Numbers
Type BF Applied Part
(Administration Sets)
Year of Manufacture
Attention: Consult Ac-
companying Documents
Transportation/Storage
Temperature Limits
Transportation/Storage
Humidity Limits
Manufacturer
Non-Ionizing Electroma-
gnetic Radiation

Controls

1
ON, Applies power to unit.
2 OFF, Turns power off except to battery charger.
3 ,Increases flow/infusion rate when pressed
and held. Increases dose rate after SET DOSE LIMIT
Key has been pressed.
4
, Decreases flow/infusion rate when pressed
and held. Decreases dose after SET DOSE LIMIT
Key has been pressed.
5
RUN/PAUSE, Alternately starts and stops unit.
Corrects alarm condition and restarts unit when
pressed twice.
6
RESET, Resets volume delivered display to 0.
7 SET DOSE LIMIT, Allows dose to be set and
displays the dose limit.
8
INFUSION RATE DISPLAY, Indicates delivery rate.
9 VOLUME DELIVERED DISPLAY, Constantly
EN
3