Water Connections - AERMEC FCL 32 Manual De Instalación

WATER CONNECTIONS

The water connections are made with flat fittings
complete with seal gaskets (supplied).
In the 4-pipe version of the unit, it is essential to
install the valve accessory for the hot water coil;
use the supplied gaskets. The accessory comes
FCLI 600x600
inlet fitting main battery
air vent
main battery
inlet fitting
secondary battery
valve vent water
valve vent water
secondary battery
main battery
For the proper discharge of air and water through the special valve is ne-
cessary to remove the condensate drain pan, as shown on the previous page
For proper water drainage and must make sure that the hydraulic connections
main are closed.
Mod. FCL
Standard coil connections (2)
Additional coil connections (4)
complete with gaskets for connection to the
system.
Information for the correct installation of the
valve is contained in the accessory instruction
booklet.
output connector
main battery
output connector
secondary battery
Always use a
wrench and
counter-wrench
to fix the pipes.
32 36 42 62
ø
ø
air vent
main battery
inlet fitting
main battery
inlet fitting
secondary battery
valve vent water
secondary battery
For proper drainage of water through the drain valve is necessary to
remove the condensate drain pan, as shown on the previous page
For proper water drainage and must make sure that the hydraulic con-
nections main are closed.
72 82 102 122 34
3/4"F
--
IFCLIJ 1805 - 4528500_09
The delivery and return pips must be equal,
suitably scaled and insulated to avoid heat
dispersion and dripping during cold functioning.
FCLI 840x840
air vent
secondary battery
output connector
main battery
valve vent water
main battery
38 44 64 84
3/4"F
1/2"F
output connector
secondary battery
Always use a
wrench and
counter-wrench
to fix the pipes.
104 124
29