Checkpoints; Surface Burner - Samsung NX58H9950W Serie Manual De Instrucciones

Troubleshooting
If you encounter a problem with the gas oven, first check the table below and try the suggestions.

Checkpoints

Gas safety
Problem
You smell gas.

Surface burner

Problem
All burners do not light.
Surface burners do not
light.
Surface burner clicks
during operation.
Possible cause
There is a gas leak.
The surface burner knob is not in
the OFF position and the burner
is not lit.
Possible cause
The power cord is not plugged
into the electrical outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
The gas supply is not properly
connected or turned on.
The control knob is not set
properly.
The burner caps are not in place.
The burner base is misaligned.
The control knob has been left in
the LITE position.
English - 61
Action
Clear the room, building, or area
of all occupants.
Immediately call your gas supplier
from a neighbor's phone. Do
not call from your phone. It is
electrical and could cause a spark
that could ignite the gas. Follow
the gas supplier's instructions.
If you cannot reach your gas
supplier, call the fire department.
Action
Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the
circuit breaker.
See the Installation Instructions
that came with your range.
Push in the control knob and turn
it to the LITE position.
Clean the electrodes.
Put the burner cap on the burner
head. Align the burner base.
After the burner lights, turn the
control knob to a desired setting.
If the burner still clicks, contact a
service technician.