Storage; Trouble Shooting - Stanley SL18129 Manual Del Propietário

3. Wipe out with dry cloth.
Before prolonged storage or as needed (i.e.: waste water pick up) the tank should be disinfected.
To disinfect the tank:
1. Pour 1 gallon of water and 1 teaspoon chlorine bleach into the tank.
2. Let solution stand for 20 minutes, carefully swishing every few minutes, make sure to wet all inside surfaces of the
tank.
3. Empty drum after 20 minutes. Rinse with water until bleach smell is gone. Allow tank to dry completely before sealing
the power head on the tank.

STORAGE

Before storing your vacuum, the dust tank should be emptied and cleaned. The cord should be wrapped around the unit.
Accessories should be kept in the same area as the vacuum so they can be readily available. The vacuum should be
stored indoors.
WARNING!
TO ASSURE PRODUCT SAFETY AND RELIABILITY, REPAIRS AND ADJUSTMENTS SHOULD BE PERFORMED
BY AUTHORIZED SERVICE CENTER, ALWAYS USING ALTON REPLACEMENT PARTS.
1. The cord can be wrapped around the cord wraps provided on the tank cover.
The other accessories can be stored on the accessories holder. （Picture 20 & 21）
2.
20

TROUBLE SHOOTING

WARNING
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS AND/OR ELECTRICAL SHOCK, TURN POWER
SWITCH OFF AND DISCONNECT
TROUBLESHOOTING CHECKS.
Minor problems often can be fixed without calling Alton Customer Service.
PROBLEM
Vacuum will not run
Loss of suction wet pick-up
Loss of suction dry pick-up
GROUNDED PLUG FROM ELECTRICAL OUTLET BEFORE PERFORMING
CAUSE
No electricity
Full tank
Clogged hose
Clogged filter
Full tank
Clogged hose
Clogged filter
-8-
Make sure electrical outlet has voltage. (A qualified
electrician may need to be contacted)
Drain and clean tank (follow instructions on page 6)
Remove hose and clean debris
Clean or replace filter (follow instructions on page 7)
Drain and clean tank (follow instructions on page 6)
Remove hose and clean debris
Clean or replace filter (follow instructions on page 7)
SOLUTION