Power Head Assembly; Operation - Stanley SL18129 Manual Del Propietário

POWER HEAD ASSEMBLY

1. Install the power head assembly onto the tank assembly as shown. （Picture 8）
2. Rotate both latches up and press until you hear them snap over the flanges on the tank. (Picture 9）
ACCESSORIES ASSEMBLY
1. Insert the flexible hose (part B) end into inlet of tank. The hose should be snapped into place.（Picture 10）
2. To remove the hose from vacuum, press the release button in the hose assembly and pull the hose out of the
vacuum inlet.
3. Attach the extension wands (part F) to the accessories end of the wands. （Picture 11）
4. Attach one of the cleaning accessories (depending on your cleaning requirements) on the extension wands.
(Picture 12 & 13）

OPERATION

ATTENTION!
THE FILTER MUST ALWAYS BE IN CORRECT POSITION TO REDUCE THE RISK OF LEAKS AND POSSIBLE
DAMAG TO VACUUM.
VACUUMING LIQUIDS
1. When picking up small amounts of liquid the cartridge filter (part J) may be left in place.
2. When picking up large amounts of liquid we recommend that the cartridge filter (part J) be removed. If the filter is
not removed, it will become saturated and misting may appear in the exhaust.
3. When the liquid in the tank reaches a predetermined lever, the float mechanism will rise automatically to cut off
air-flow. When this happens the motor will develop a higher than normal pitch noise and the suction is drastically
reduced. Please turn off the vacuum, unplug the power cord, and empty the tank.
filled with liquids, the red indicator in the power head cover can also light)
4. After using the vacuum to pick up liquids, the cartridge filter (part J) must be dried to reduce the risk of possible
mildew and damage to the filter.
VACUUMING DRY MATERIALS
WARNING!
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET BEFORE REMOVING THE POWER
HEAD.
1. To pick up wall dust and dry material, the disposable filter bag (part K) can be used for filtration.
2. To pick up wall dust and dry material, the cartridge filter (part J) can be used for filtration.
3. But disposable filter bag (part K) plus filter (part J) can be used for better filtration. When using your vacuum to
pick up very fine dust, it will be necessary for you to empty the tank and clean the filter at more frequent intervals
to maintain peak vacuum performance.
NOTE: If you use your vacuum to pick up dust when the filter is wet, the filter will clog quickly and be very difficult to
clean.
4. If your filter (part J) is wet but you need to use filter to pick up dry material, you can quickly dry the filter by running
the vacuum without hose attached for about 10 minutes. The clean air rushing through the vacuum will help dry the
filter
FILTER PERFORMANCE INDICATOR
1. When the indicator is dark that indicate your filter is clean and ready to use.
2. When the indicator is light that shows your filter is dirty and needs to be cleaned or replaced or the vacuum clog, it
need to be clean.
-5-
(NOTE: On the condition the tank is