Metra 99-3018 Instrucciones De Instalación página 13

12-pin pre-wired ASWC-1 harness
• This harness is to be used in conjunction with the optional ASWC-1 (not
included) to retain steering wheel controls. If the ASWC-1 is not being used,
disregard this harness. If it will be used, please refer to the ASWC-1 instructions
for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
Note: The relay attached to the 3018 harness is only for audible turn signal clicks.
No extra steps are required to retain this feature, so leave the relay as-is.
Note: There is an 8-pin harness connected to a small heat shrink wrapped circuit
board: DO NOT DISCONNECT! The circuit board must remain connected to allow
proper operation of the kit.
99-3018
Connections to be made
13
(Cont)