Metra 99-3018 Instrucciones De Instalación página 4

Unless otherwise stated, ensure that
the vehicle is completely off before
proceeding onto the following steps:
5. Remove (2) 7mm screws from the
bottom of the radio/climate control
panel and unplug & remove the
panel (Figure G)
(WARNING!!! Do not unplug the
panel if the vehicle has factory
navigation, continue to step 6).
Dash Disassembly
(Figure G)
(Figure H)
99-3018
(Cont)
6. Navigation models only: With
the radio/climate control panel
still connected, cycle the key to
accessory, and then press the button
on the upper left of the panel to
raise the navigation screen. Remove
(3) 7mm screws holding the screen
into the dash, unplug and remove
the screen, turn the key to the off
position, and then remove the key
from the ignition. Now it is safe to
unplug and remove the radio/climate
control panel. (Figure H)
Note: Failure to follow this step
properly will result in the airbag
light illuminating in the instrument
cluster.
7. Remove (4) 7mm screws from the
radio chassis, and then unplug and
remove the radio chassis from the
dash. (Figure I)
Continue to Kit Preparation
4
(Figure I)