General Safety Instructions; Mounting The Spray Gun; Supply Line Connection; Operation - WALTHER PILOT GA 9010 Traducción Del Manual De Instrucciones Original

Note
The pictogram and the urgency level "Note" identify additional information for the
safe and efficient operation of the spray gun.
3.2

General safety instructions

• Observe applicable national accident prevention regulations and other acknow-
ledged health and safety regulations.
• Use the spray gun only in well ventilated rooms. Fire, naked flame or smoking are
not permitted in the work area. Spraying of highly flammable materials (e.g. lac-
quers, adhesives, cleaning agents, etc.) poses an increased risk to health, of
explosion and fire hazards.
• It is necessary to ensure that the spray gun is adequately earthed separately or
in connection with the equipment it is mounted on (max. resistance 10
• Before any maintenance or repair, the air and material supply to the spray gun
must be depressurised - risk of injury.
• When spraying materials, do not hold hands or other parts of the body in front of
the pressurised nozzle of the spray gun - risk of injury.
• Never point the spray gun at persons or animals - risk of injury.
• Observe the processing and safety instructions of the spraying material and
cleaning agent manufacturers. Aggressive and corrosive materials in particular
can be harmful to health.
• Wear hearing protection in the operating area of the spray gun. The sound level
generated by the spray gun is approx. 83 dB (A) and can harm your hearing.
• Particle-conveying discharged air must be kept away from the work area and
operating personnel. In spite of these measures, always wear the regulation
respiratory protection and work clothing when processing materials with the
spray gun. Airborne particles can damage your health.
• After completing assembly and maintenance work, always make sure that all nuts
and bolts have been retightened.
• Always use original replacement parts, as WALTHER can only guarantee the
safe and fault-free functioning of these parts.
Please contact WALTHER Spritz- und Lackiersysteme GmbH, Wuppertal, for further
information regarding the safe use of the spray gun.
4 Installation
The spray gun has been completely assembled at the factory. The following tasks
must be performed before starting the operation of the spray gun.
Ω).
6
34
4.1

Mounting the spray gun

Mount the spray gun on a suitable stable holder, as described below:
(1)
4.2

Supply line connection

Warning
Make sure that you do not mix up the control and atomiser air supplies by mistake
- risk of injury.
(3) (1)
alternative
(3)
(2)
2. Ensure that hoses are attached securely.
The spray gun is now fully mounted and can be commissioned.
5

Operation

5.1

Start-up and shut-down

The following requirements must have been met before you can operate the spray gun:
• The control air pressure must be applied at the spray gun.
• The atomiser air pressure must be applied at the spray gun.
• The material pressure must be applied at the spray gun.
35
Use the two M 4 holes (1) with a spa-
cing of 30 mm.
Other attachment equipment
request.
e.g.
Item number
Gun holder V 21 300 25 000
1. Fasten the supply line
• for the spraying air to the connection
marked (1) on the spray gun
(M 7 - PK 4)
• for the control air to the connection
marked (2) on the spray gun
(M 5 - PK 3)
• for the material supply/circulation
method to the connection marked (3)
on the spray gun (G 1/8" - 5 mm ø)
on