Before Washing; Operating - Danby DWM17WDB Guía De Uso

Operating Instructions
Prepare the wash load. Mix large and small articles in a load to get the

BEFORE WASHING

best washing results. Drop articles loosely into the inner tub. Do not pack
articles in or wrap them. Articles should move freely through the wash
water for best cleaning results. Articles should rollover, sink and then
reappear.
When washing very large articles, do not fill inner tub as full as with other
loads. The water level in your washer should fit the size of your wash load.
Small load will use lower water levels. There must be enough water in the
inner tub to allow articles to move and turn over freely. Overloading the
inner tub can result in poor washing and rinsing. Overloading may also
cause wrinkling and tearing of articles.
WATER LEVEL
RIGHT WRONG
Press down the power button.

OPERATING

Press down the water level button.
Choose appropriate water level according to wash load quantity and then
the corresponding indicator will blink.
Water temperature choice
Push down the water temperature choice button, you can choose the inlet
(cold water or hot water). When the cold-water indicator and the hot-water
indicator turn on simultaneously, means you chose the warm water.
NOTE: The washer will provide a cold rinse in all TEMPERATURE
settings.
IMPORTANT: A single cold hose system does not allow the washing
machine to automatically (select) regulate incoming water temperatures to
match those listed on the control panel such as WARM or HOT.
Press down the program select button.
Choose the appropriate program mode according to wash load quantity
and then the corresponding indicator blink.
Press down the function select button.
Choose the desired function group and then the corresponding indicator
will blink.
Press down the Start/Pause button once and the machine will begin
operation.
Please press this button to stop the normal operation, if it continues to
work, press it again. Water level can be reset during the normal operation.
If higher water level is selected, the machine will operate after refilling the
water.
10