Installation - Luisi Air TORINO SILT26 Instrucciones De Uso Y De Montaje

INSTALLATION

At tge beginning make sure that the package is
intact and all the parts are unbroken, otherwise
stop the installation and contact the dealer. The
manufacturer is not responsible for damages
caused by material handling or product in-
stallation.
Before installing the appliance read all these
instructions carefully.
WARNING: This product is made of ceramics,
for that reason it requires an appropriate and
accurate handling, as well as a professional
and accurate installation.
Extract the product from the packaging and lay it
on a suitable place, a soft material such as spon-
ge or fabric should be used to place the product
on it.
By using the supplied drilling jig, perforate the
wall according to the four pattern indicated by the
jig itself. The center of the drilling jig should cor-
respond to the center of the cooktop. Insert the
supplied dowel into the holes made, tighten them,
but do not tighten until they are flush; the three
screws into the dowels corresponding to the ho-
les with discharge head (Fig.8 A) leaving the hole
for the locking screw empty (Fig. 9 B) because it
will be added later.
Place the ceramic cover over the suctioning ele-
ment and insert the steel cables into the three
holes of the ceramic, as shown in the figure (Fig.
1). Put the power cable through the air outlet grill,
see Figure 2 The ceramic part must perfectly
cover the metal part named "D" in the exploded
view.
Extract from the packaging the ceramic cover for
the ceiling plate (see the detail B on the exploded
view), place the cover over the hood and put the
steel cables through the three holes in the cera-
mic body, the power cable should be put through
the central hole of the ceramic, see Fig.3. Extract
the metal plate from the packaging and then put
the steel cables through the appropriate sup-
ports, as shown in figure 4.
Adjust the height of the product scrolling the steel
cables up and down inside the support, it is ne-
cessary to unscrew and push the support in order
to allow the scrolling of the cable, see fig. 5.
Check that the remaining length of steel cables
from the supports indicated in fig. 6 is the same,
in order to ensure that it will be installed perfectly
parallel to the ceiling. Tightening the appropriate
support by screwing it as shown in fig.6, block
the steel cables. Add the clips as a further safety
precaution for cable blocking fig. 7. Put the hood
near the ceiling and hook the plate to the screws
previously installed (fig. 8A) Tighten the three
screws fixing the plate to the ceiling, then block
the hood definitively adding the security screw ,
see fig. 9B.
Connect the appliance to the electric grid.
Lift up the ceramic cover until reaching the ceiling
(fig. 10), make sure that the springs have hooked
the ceramic cover.
Install the grease filter making sure to hook first
the security steel cable, as shown in fig. 16.
The grease filter must be positioned by orienting
the dedicated opening, near the speed indicator
(fig. 17).
In case the ceramic cover of the body, is not per-
fectly flat or parallel to the body, it is possible to
make an adjustment after installation.
Remove the grease filter as described in Main-
tenance Section. Using a Phillips screw head
screwdriver, (fig. 13A) tighten or loosen the three
screws in order to raise or lower the ceramic body
on a specific side (fig. 14). After the adjustment
insert the rubber tips and the grease filter again.
15