Starting The Machine; To Operate; Operation On Slopes; Forward/Reverse/Nuetral - Stone WolfPac WP6100 Manual Del Operador

Ocultar thumbs Ver también para WolfPac WP6100:
Tabla de contenido

Publicidad

TARTING THE MACHINE

Operator must always be seated and seat belt must be worn.

Forward/reverse must be in NEUTRAL position.

Throttle should be set at idle.

Turn key counterclockwise to “preheat” position until preheat lamp turns off.

Turn key clockwise until the engine cranks over. Release the key when the engine
starts. DO NOT crank the engine for more than 20 seconds at a time.

TO OPERATE

Apply full throttle and move forward/reverse lever slowly forward to gain speed desired. Use
the same procedure for reverse. To slow down move forward/reverse lever towards neutral.
To gain power or speed, move the forward/reverse lever slightly off neutral. This will produce
the greatest amount of torque. Moving the lever all the way forward or reverse will give the
greatest amount of speed.
OPERATION ON LOPE
15
ever operate on slopes greater than 15 degrees or tipping may occur, resulting in
FORWARD/REVER E/NEUTRAL
The forward/reverse lever should be aligned with "NEUTRAL" on the console when the roller
is not moving forward or backward and the engine is running. The neutral interlock switch
should not allow the engine to start unless forward/reverse lever is in neutral.
HUTTING THE MACHINE OFF

elect a safe area where it will cause the least obstruction and inconvenience to
others.

Before stopping, turn vibration OFF.

Return control lever to the NEUTRAL position, this will stop the machine
immediately.

Throttle engine down to idle speed, idle engine for 2-3 minutes. DO NOT idle engine
for long periods.

Turn the key to the OFF position to stop the engine and set brakes. Remove ignition
key.
Never operate the machine in violation of the tip angle. Refer
to the technical Data ection for tip angle and gradeability.
Running the machine in excess of tip angle will cause the
machine to be unstable. This could result in operator injury or
engine/machine damage.
Tip
angle
WARNING
personal injury.
Operation
CAUTIO : Idle engine
2-3 minutes before
stopping. This will allow
engine to cool.
WolfPac
6100
TM
29

Publicidad

Tabla de contenido
loading

Productos relacionados para Stone WolfPac WP6100

Tabla de contenido