Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP
8
Connect Tubing (Continued)
AIR GAP FROM FAUCET TO RO ASSEMBLY
Locate 1/4" Red Plastic Tubing already attached to the air gap barb on the
1 A
RO Faucet Body .
P
Determine length necessary to connect to the drain outlet on the RO Membrane Filter
2 A
Cut 1/4" Red Plastic Tubing
R
square and to length with sharp utility or exacto knife.
3 A
I
nsert Restrictor
I
into end of 1/4" Red Plastic Tubing .
4 A
NOTE: SYSTEM WILL NOT OPERATE WITHOUT RESTRICTOR.
Remove black plug from RO Membrane Filter
5 A
pulling plug with other hand. Discard plug.
Insert 1/4" Red Plastic Tubing
R
6 A
B2
Filter
approximately 5/8" until it stops.
Pull on the 1/4" Red Plastic Tubing
7 A
CONNECT 3/8" RED TUBE FROM REVERSE OSMOSIS FAUCET TO DRAIN ADAPTER
Locate the 3/8" Red Plastic Tubing
1 B
The other end needs to be attached to the collet on the sink Drain Connector .
2 B
Cut 3/8" Red Plastic Tubing
T
3 B
without loops, dips, low spots, or kinks.
Cut the end of the 3/8" Red Plastic Tubing
4 B
Insert all the way into the fitting approximately 1" until it stops.
5 B
Pull on the tube to be sure it is held firmly in the fitting.
6 B
CONNECT TUBING FROM RO SYSTEM HEAD TO WATER STORAGE TANK
Use the remaining 3/8" White Tubing
1 C
to connect the Tank outlet (labeled "TANK") on RO System Head
E
Water Storage Tank
.
Cut 3/8" White Plastic Tubing
U
2 C
Wet the end of tubing and Insert into compression nut of Tank Connector
3 C
was connect to tank previously.
Tighten compression nut to secure tubing to Tank Connector .
4 C
5 C
Insert the other end of 3/8" White Plastic Tubing
System Head
A
(labeled "TANK") approximatley 5/8" until it stops.
NOTE: Tubing lengths should allow for the removal of the assembly from the mount screws
for servic ing. If tubing lengths are shortened for neater appearance, it may be necessary to
keep the assembly on the mount sc rews for servic e.
NOTE: Codes in the state of Massac husetts require installation by a lic ensed plumber and do
not permit the use of saddle valves. If you live in the state of Massac husetts, review plumbing
c ode 248-CMR of the Commonwealth of Massachusetts before proc eeding with the
installation.
WFRO60X-1
R
R
B2
drain port by pushing on white collar while
all the way into the fitting on bottom of RO Membrane
R
to be sure it is held firmly in the fitting.
T
already attached to the RO Faucet Body
as needed to route in as straight of a run as possible,
T
square with a sharp utility or exacto knife.
U
from Step 6 and determine length necessary
A
to the
square with a sharp utility or exacto knife.
D
U
into the outlet of the RO
8
B2
.
P
.
K
B2
D
fitting. Which
A
9
S
T
K
F
B2
U
R
I
4 A
B2
5 A
R
A
3 C
U
P
D
A
U
E
6 A
R
D
4 C
U
E
V4.4
Publicidad
Tabla de contenido
