Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP
9
Install RO System and Drain In Remote Location
INSTALL A REMOTE DRAIN POINT AND AIR GAP (Remote Location)
You can also run the drain tubing to an existing drain in the house. A floor drain, laundry tub, standpipe,
sump, etc. are suitable drain points. This type of drain is preferred over the drain connector. Check your
local codes. Longer lengths of tubing (see parts list in manual) may be needed.
Always be sure to provide an air gap between the end of the hose and the drain point. This will prevent
water from backing up into the system. Air gaps are required code in most areas.
TO INSTALL A REMOTE DRAIN POINT, COMPLETE THE FOLLOWING STEPS:
Remove the 1/4" Red Plastic Tubing
R
1
Determine if this length is long enough to reach the drain point. If it is, then insert Restrictor
2
tubing and then insert this end of tubing into drain port on RO Membrane Filter
If not, replace the 1/4" Red Plastic Tubing
3
Then insert Restrictor
I
in end of tubing and then insert this end of tubing into drain port on RO
Membrane Filter
B2
. Refer to Step 6 in manual on how to disconnect and connect tubing.
Run the tubing to the drain point and secure at the end with a bracket (purchased locally).
4
Provide a 1-1/2" air gap between the end of the tube and the drain.
Remove 3/8" White Plastic Tubing
T
5
Faucet will not have 1/4" or 3/8" tubing attached to the airgap barbs in the RO Faucet Body
6
remote installation.
WFRO60X-1
from the RO Faucet Body by pulling gently.
P
R
with an adequate length of tubing to reach the drain point.
from RO Faucet Body
P
and discard.
9
I
in end of
B2
.
P
for
10
V4.4
Publicidad
Tabla de contenido
