KRATOS SAFETY KS2001 Guia De Instalacion página 11

If an absorber is fitted to the top point: Connect the cable directly to the swivelling part of the absorber, using the fastenings
l
supplied with the absorber. Tighten the nut reasonably without excess, making sure that at least 2 threads are visible on the screw
after tightening.
The connection between the top anchorage (or the absorber) and the anchor line plays a key role in the event of a fall; pay
particular attention to it.
1.4) INTERMEDIATE ATTACHMENT POINTS:
KRATOS SAFETY intermediate attachment points hold the cable over the length of the structure. When it is held in this way, the cable
Material:
Stainless Steel SS 316 L
Fastenings:
STAINLESS STEEL (316 A4-70)
Weight:
0.650 kg
does not damage the structure, and vice-versa. The system user passes these intermediate points without needing to disconnect the fall
prevention device from the anchor line.
They should be installed every 8 metres, we recommend spreading the spaces evenly on either side of an intermediate part.
Tools required:
Two 13 mm spanners or 2 adjustable spanners.
Installation:
Prepare the intermediate attachment point taking care to align it with the top anchorage point,
Fix the intermediate attachment point with its backing plate using the fastenings supplied,
The installation of this type of assembly does not require tightening with a torque wrench.
The fastenings and any accessories supplied are designed to suit your situation; if in doubt contact us!
1.5) BOTTOM ATTACHMENT POINTS:
The bottom attachment point and the anchor line tensioning system determine the type of installation that you will have EN353-1 or
EN353-2.
Case 1: Installation of an EN353-1 system: Mobile personal protective equipment against falls from a height on a rigid anchor line: the
installation is fitted with a tensioner on the cable.
In this case, the bottom attachment is the same as the top attachment; refer to the "TOP ANCHORAGE" paragraph for installation.
Case 2: Installation of an EN353-2 system: Mobile personal protective equipment against falls from a height on a flexible anchor line:
the installation is fitted with a counterweight on the cable.
In this case, follow the instructions hereunder.
The bottom attachments for the flexible KRATOS SAFETY system are designed to be able to be installed on the following support
Material:
Steel and polymer
Fastenings:
STAINLESS STEEL (316 A4-70)
Weight: 1.080 kg
structures:
Tools required:
Two 13 mm spanners or 2 adjustable spanners.
Installation:
Prepare the bottom attachment taking care to align it with the top anchorage point or intermediate attachment point,
Place this bottom attachment point sufficiently high to allow the action of the counterweight; allow about 60 cm under the bottom
attachment point.
Fix the bottom attachment point with its backing plate using the fastenings supplied,
The installation of this type of assembly does not require tightening with a torque wrench.
The fastenings and any accessories supplied are designed to suite your situation; if in doubt contact us!
- 10 -
PART NUMBER: FA 20 202 00
A
( < 40 mm ) _
PART NUMBER: FA 20 203 00
A
( < 40 mm ) _