Start-Up; Remote Control; Operation; Selecting The Light Colour - LIVARNO LUX IAN 280090 Instrucciones De Utilización Y De Seguridad

Remove dead batteries from the device
immediately!

Start-up

Lamp
Before first use, screw the included lamp
into the E27 socket of a light. When doing
this, ensure that the lamp is securely seated.
Note: The lamp has a weight of approx.
100 g and measures approx. 6 x 11 cm.
Verify the lamp may be used with the
respective light before use.
Connect the lamp used to the mains and
switch it on.

Remote control

Before first use, remove the battery insulat-
ing strip between the battery
battery compartment
control .
2
Press the ON button
control to switch the lamp on (Fig. A).
Note: Please note the remote control uses
infrared lamp: it does not allow the signal
to be transmitted „around the corner" as
radio waves do. Light-tight objects may not
1
and the
16
of the remote
13
on the remote
6
be located between the diode
light.
The lamp will now light up white.
1

Operation

Select a light colour or different colour change
effects using the remote control

Selecting the light colour

Press one of the colour buttons
W button to select a light colour corre-
7
sponding with the button.
Press the button
the light intensity.
Press the button
the light intensity.
There are 5 brightness settings to choose
from.

Colour change selection

FLASH: Press the FLASH button
select a colour change pattern alternating
and the
14
(Fig. A):
2
or the
12
to gradually increase
3
to gradually reduce
4
to
8
GB/MT 31